Griffon 6303764 PolyMax High Tack Express white 435g
Special features
- Very high initial adhesion
- Very rapid strength build-up
- Permanently elastic
- Very good filling capacity
- Good sag resistance
- Does not shrink, 100% adhesive
- Solvent-free
- Does not soil edges
- Weather resistant
- Temperature resistant from -40°C to +100°C
- Paintable
- Curing approx. 1.6 mm/24 hours
- Solvent-free assembly adhesive with very high initial adhesion and very rapid strength build-up based on SMP Polymer. Particularly suitable for heavy materials
- For bonding and mounting many building materials on virtually all substrates, such as wood, plaster, (natural) stone, (aerated) concrete, metal, rigid foam, and PLS plastics
- Metal stud interior walls: bonding/mounting U-profiles on floor, ceiling, and wall
- Suitable for indoor and outdoor applications, such as panels, ceiling elements, fascia boards, plasterboard, sheet and insulation materials, mirrors, framing, skirting boards, and battens
- For all professional applications, such as facade and interior construction, residential, commercial, and automotive construction
Technical data
- Not suitable for PE, PP, PTFE, pure gypsum, and bitumen. Always perform an adhesion test first when bonding plastic. Adhesion to plastic may vary depending on the type and quality of the plastic. Remove wet adhesive residue immediately with turpentine. Dried adhesive residue can only be removed mechanically. Consumption: 1 cartridge yields approx. 7-9 meters of adhesive. Store dry in a closed container between +5°C and +25°C. Contents: 435 g. Instructions for use. Apply adhesive evenly in vertical stripes or dots every 10 to 40 cm, depending on the weight of the material. Always apply adhesive to corners and along edges. Mounting of materials (facade panels) can be compensated for by an adhesive thickness of 3 mm (use spacer blocks or tape). Mount materials immediately with a sliding motion and press or tap firmly into place. Correction is still possible
- Close the cartridge tightly immediately after use
- The ambient temperature, the adhesive, and the materials to be bonded must not be lower than +5°C
- Parts must be clean, dust-free, and grease-free. Ensure a firm surface. The surface may be slightly damp. Use of primer is not necessary
- Before use, open the cartridge at the top by cutting off the plastic nipple above the screw thread with a sharp knife. Then attach the nozzle and cut it at an angle (opening min. Ø 5 mm)
Comment